Expect to pay at least $ 1965 for labor on garage door opener installation. Usually it takes between 2 and six hours to properly install a garage door opener; however, it can take longer. If your garage door is higher than seven feet, you’ll need an extra extension kit, which will cost an additional fifty dollars. Most garage door opener installation instructions will tell you how to measure and cut the steel cables that make up the garage door opener system. If you’re unfamiliar with garage door opener installation, be sure to follow all necessary instructions to prevent damaging your garage door.
If you are having garage door opener installation done by a professional installer, you should expect to pay at least a minimum of two hundred dollars for labor. This includes not only the actual hardware, but also installation materials like screws, washers, and clips. Garage door trolleys are usually not included in the installation price, so you’ll have to purchase these separately. If you have the ability, you may also want to include a tie down strap to keep your garage door trolley from becoming loose. The installation process can be quite messy, so if you’re unfamiliar with installing trolleys, it’s usually best to have a professional perform the job.
Before beginning garage door opener installation, you should have everything you need ready. Most outlets that are used to plug in garage door openers require a power wire to be run from the wall. Be sure that all of your power cords are attached securely to no loose wire, and then connect all of the components. Some installation packages include detailed, step-by-step installation instructions, and if not, you can purchase separate installation instructions or even watch a video for assistance. Installing a garage door opener can often be confusing, so it’s always a good idea to follow installation directions closely.
One important component of garage door opener installation is the hardware that holds the trolley to the track. Most openers will come with hardware that already has mounting brackets pre-drilled into them; if not, you’ll need to purchase special brackets and use screws that are included in your hardware. The mounting brackets will typically mount the toaster to the top track, and then the carriage tube will extend out across the opening. The carriage tube will be secured to the bottom track via towing straps, and then the whole thing will be fastened to the ceiling using ceiling screws.
After mounting the garage door opener motor pro, you can proceed to the actual garage door installation. Start by testing the trolley’s operation by lifting and lowering it several times without engaging the overhead trolley handle. Also, check to see that the motor has been installed and that all high-tension springs have been installed and adjusted.
It’s also important that all parts of the garage door opener installation are installed and adjusted correctly. If the trolley is improperly fitted with the springs aren’t adjusted properly, the motor won’t be able to work efficiently enough and could malfunction. Also, you must install all electrical wiring correctly. High-tension springs will need to be checked to ensure that they’re properly tensioned. It’s usually best to take the garage door opener installation to a garage repair or garage door technician, but there are many garage door opener installers on the Internet who can do the job. All you need to do is follow the instructions carefully.